Recent Articles
Sorry, no articles were found.
 

Warrior Assembly (TBBX12)

Warrior Assembly (TBBX12)

Warrior Assembly (TBBX12)

How to assemble your Warrior Transports.

Check out the Warrior Platoon spotlight here...

Assembling The Plastic Warrior

Step 1. Begin by attaching the left and right side tracks to the lower hull piece.

Step 2: Next attach the rear plate to the back of the the lower hull.

Below: The rear plate and the left and right side tracks in place.

Step 3. Attach the hupper hull to the main lower hull piece we have assembled.

Step 4. Attach the side-skirts to the main hull. Note the slots to help you align them properly. 

Below: The side-skirts in place on both sides of the model. 

Note: If you are planning to to make an Uparmoured Warrior you should got to Step 9.

Step 5. Next we will start building the turret. Start with the upper turret hull and attach the two smoke dischargers

Below: The smoke discharger in place. 

Below: The smoke discharger in place

Step 6. Now glue the top hatch in place on the turret. Note that you can leave this hatch up to place a tank commander.

Step 6. Attach the storage basket to the read of the turret. 

Below: The assembled turret with hatch and storage basket in place.

Step 6. Attach the bottom hull plate and insert a turret peg or magenet into the slot below.

Below: The fully assembled Warrior.

Note that the uparmoured is continued below.

Step 7. We will now start making an Uparmoured Warrior. Start with the upper front armour plate in the location shown below.

Step 8. Attach the bottom part of the front armour plate in the location shown below. 

Below: The bottom front armour plate in place. Note the alignment of the slot at the axel.

Step 9. Attach the right side uparmoured side skkirt to the hull. Note there are slots to help you align them correctly.

Step 10. Attach the left side uparmoured side skkirt to the hull. Note there are slots to help you align them correctly. With this the hull is now finished. 

Step 11 (optional). You can mount a Milan launcher on your Up armoured Warriors. Glue it in place on top of the turret in the slot shown below.

Step 11 (optional). The fully Assembled Uparmoured Warrior.