TOS-1 Thermobaric Rocket Launcher Battery Assembly (TSBX25)

	TOS-1 Thermobaric Rocket Launcher Battery Assembly (TSBX25) Assembly guide on how to assemble your TOS-1 Thermobaric Rocket Launcher Check out the TOS-1 Thermobaric Rocket Launcher spotlight here...

Step 1. Begin assembly of your TOS-1 by glueing on the tracks. There are different spaced notches to ensure you don't put them on backwards.		Step 2. Next glue on the back plate.

Below: You'll notice that the plate sits a bit higher than the hull right now - this is normal.	Step 3. Glue the top and bottom hull together. You'll notice now that the back plate fits perfectly with the top assembled.

Step 4. Glue the side skirts onto the hull by lining up the two notches. This can be a little tricky.	Note: The two side skirts are different. The left-hand side skirt has a small notch taken out of it. This is to make way for the exhaust.

Step 5. Assemble the fuel drums by gluing a top and bottom piece together. The difference is illustrated to the right.

Step 6. Next glue the assembled fuel drums to the rear of the hull. The mounting brackets should be facing the ground.		Step 7. Finish off the hull assembly by gluing the unditching beam to the locating tabs on the rear.

Step 8. Now we will build the turret. Attach the rear section of the rocket launcher to the main launcher part. Important Note: This section will require you to use superglue

Below: Note the notch on the bottom of the launcher assembly.	Step 9. Tattach the launcher system to the turret base piece. Note that the hydraulic lift fits into the slot shown on the left.

Below: The Completed Missile launcher section. Note the sitting of the launcher on the hinges at the back.

Below: The Completed TOS-1 Rocket Launcher